Dawlance DWT 255 User Manual

07
Water inlet installation
Before using
Connect the inlet hose connector with the inlet hose
Check the connection between inlet hose
connector and the tap
Inlet valve connector
Inlet hose nut
Water absorption cushion
Lock lever
Inlet hose connector
Slider
1. Push down the slider and insert the inlet hose into the connector.
2. Hang the lock lever to the inlet hose connector and release
the slider till a click sound is heard.
1. Swing the inlet hose gently to conrm if it is fastened.
2. After installation, open the tap and check if it leaks.
3. Do not bend the inlet hose with overstrain.
4. Before each usage, check the connection between
inlet hose connector and the tap. Also, make sure that the
inlet hose is installed properly. Conrm that they are rmly
tted to prevent dropping from improper installation position.
Slider
Lock lever
Connect the inlet hose with the washing machine
1. Do not take off the water absorption cushion. Please
check if the cushion is dropped or damaged before
each use. If it is, contact the seller immediately.
2. Put the inlet hose nut on the inlet valve connector.
3. Fasten the inlet hose nut and swing it gently to make
sure if it is suitable.
1. Close the tap.
2. Press the locking lever, push down the slider, and pull off the
inlet hose. If the machine is used frequently, the connector
of the inlet hose can be kept on the tap to prevent damage to
the xing screw.
Dismantle the inlet hose
Cautions: When installing the washing machine, please use the new hose along with the washing
machine. Old hose cannot be reused.
07

Dawlance DWT 255 Specifications

General

Brand	Dawlance
Model	DWT 255
Category	Washer
Language	English