Settlement
Insert the plug tightly.
Make sure the socket is functioning, else change to another socket.
Press power switch.
Check power supply.
Install the inlet hose again.
Tighten the connector of the machine.
Restart when water supply is resumed.
Open the tap.
Clean the lter according to before “clean inlet gate”.
The machine is adjusting automatically.
Close the top lid.
Normal
Normal
Notes: If there is still a fault after the above checks, please pull out the plug and
contact the seller right away. It is dangerous to repair this product by yourself.
Put down the drainpipe.
Straighten or clean the drainpipe.
Settlement
Troubleshooting
It does not drain
It does not inlet
Spinning stops and begins to
supply water during spin
program
Press the program button to
select SPIN, but it does not work
The spin is intermittent when
spinning starts
When used for the rst time, some
water ows from the drainpipe
No water supply.
Tap is not open.
Inlet hose is blocked.
Laundry has been overloaded or underloaded or the machine
is not placed on a stable surface.
Before contacting the technicians, please make the following checks:
Control panel has no display
Plug is not inserted tightly.
No electricity is in the socket.
Power switch is not turned on.
Power supply is cut off.
Inlet hose leaks
Inlet hose connector (connecting with the tap) is not xed tightly.
Inlet hose and Washing machine connector are loose.
Drainpipe is not put down.
Drainpipe is bended or blocked.
Because of the remaining water inside, when the factory did the test.
The top lid is closed when the water is draining.
Balance the laundry to reach to the best spin effect.
Phenomena
Possible reason
15 16
To Next Page
Loading...
