17 / 20
Draining the Fuel Tank and Carburetor
If you do not use a fuel stabilizer for the conservation of fuel in the tank, it is necessary to drain fuel
from the engine.
WARNING
Gasoline is highly flammable and explosive, and you can be burned or seriously injured when
handling fuel.
Stop engine and keep heat, sparks, and flame away.
Refuel only outdoors.
Wipe up spills immediately.
1. Place an approved gasoline container below the carburetor, and use a funnel to avoid spilling
fuel.
2. Remove the drain bolt.
3. After all the fuel has drained into the container, reinstall the drain bolt and washer. Tighten the
drain bolt securely.
Note: To drain the fuel can be used the breast pump that allows you to drain the fuel from the tank
without removing the drain plug carburetor. Contact your dealer.
Engine Oil
1. Change the engine oil (see page 12).
2. Remove the spark plug (see page 14).
3. Pour a tablespoon (ca 5 ccm) of clean engine oil into the cylinder (see picture above).
4. Pull the recoil starter several times to distribute the oil in the cylinder.
5. Reinstall the spark plug.
4. Carburetor
A: Drain bolt
B: Washer
OIL
SPARK PLUG HOLE
To Next Page
Loading...
