Days MD 4 Plus - Page 22

22
Issued: 28.02.2005
Strider MD 4 Plus Adjusting the seat height
Remove the rear panelling.➨
Press the locking device on the plug
and disconnect the electric cable
connecting plug (5) to the rear lights
and rear indicators.
➨
Adjusting the seat height:
The seat height (h) is adjusted by using the
holes in the seat support.
Pull the seat support out as far as the
required height until the correct hole
appears in the seat tube hole.
Push the lower clamping bolt (7) into the
seat tube and tighten.
➨
➨
Adjusting the seat
support
Loosen the lower clamping bolt (7) and
pull the it out of the seat support (8).
➨
Tools required:
1 x Allen key (size 6 mm)
Loosen the upper clamping bolt (6).➨
Tighten the upper clamping bolt (6).➨