Need help?Do you have a question about the dbx 160X and is the answer not in the manual?
Explains the hard-wire bypass function and its status indicator LED.
How to adjust the compression threshold level for Over Easy or hard-knee modes.
Sets the amount of gain reduction applied above the threshold.
Allows adjustment of fixed gain for the output amplifier stage.
Sets the reference level for gain change circuitry in hard-knee or Over Easy mode.
Determines the gain reduction applied when input signal is above threshold.
Explains the hard-wire bypass function and its status indicator LED.
How to adjust the compression threshold level for Over Easy or hard-knee modes.
Sets the amount of gain reduction applied above the threshold.
Allows adjustment of fixed gain for the output amplifier stage.
Sets the reference level for gain change circuitry in hard-knee or Over Easy mode.
Determines the gain reduction applied when input signal is above threshold.
General| Type | Compressor/Limiter |
|---|---|
| Signal to Noise Ratio | >90dB |
| Input Impedance | 10 kΩ |
| Ratio | 1:1 to ∞:1 |
| Connectors | XLR |
| Frequency Response | 20Hz-20kHz, +0/-0.5dB |
| Power Supply | 100-240V, 50/60Hz |
To Next Page
