29
USING THE GRILL
Grate positions
As well as moving the grates to be positioned to your preference along the grill, the dual-sided
grates can also be placed flat or in an angled position. If the grates are hot, please use the multi-
tool to move the grates or re-position them. Placing the grates in an angled positioned (Fig. 21),
allows fat and grease to run off food and into the grease management system. It also allows for a
slightly slower cooking, than if the grate was placed flat (Fig. 22). If you are using a griddle plate
please ensure that the plate is flat or tilted at an upward angle, and not tilted down. Charcoal
grates can only be used in the flat position when resting on the high bar as shown in Fig. 23.
Charcoal grates
FIG. 21
• The dual-sided grates can be used in an angled position.
FIG. 23
• The charcoal grate can be used in an flat position when
sitting on the high bar.
FIG. 24b
• The sear burner grate must be used over the sear burner in
a flat position.
• Ensure the rear rod is secured via the hooks at the back of
the grill.
FIG. 22
• The dual-sided grates can be used in a flat position.
FIG. 24a
• The charcoal grate cannot be used in a flat position.
• The charcoal grate cannot be used above the sear burner.
FIG. 24c
• The sear burner grate cannot be used over the charcoal insert.
• Do not place the sear burner grate above the back rods at any
time. It must be secured via the hooks at the back.
Dual-sided grates
Sear burner grates (some models only)
EN
To Next Page
Loading...
Need help?
General
