DCS Debussy DAC - Fitting the Remote Control Handset Batteries

dCS Debussy DAC User Manual Software Issue 2.2x
August 2013
Debussy DAC Manual v2_2x.docx Page 7 English version
Fitting the Remote Control handset batteries
Use a small coin to
release the screw
securing the back
plate.
Lift the screw a
little and slide the
back plate off.
Fit 2 AA size batteries by pressing
the flat end (-) against the spring
and pressing the battery into the
slot, so that the + end makes
contact with the stud.
Slide the back
plate into place and
tighten the screw.
!
Failure to fit the batteries correctly can damage your Remote Control. Such damage is
not covered by the warranty.
Please dispose of used batteries properly at a waste disposal site, not in the household
waste.