Changing the source input
Change the source input using dCS Mosaic ACTUS.
1. On the home screen, select .
2. From the Select source drop-down, select a source.
The content of the selected source is displayed on the player screen.
The source change is reflected on the User Interface front panel.
Using the User Interface
1. On the User Interface front panel, select .
2. From the drop-down, select a source.
The content of the selected source is displayed on the front panel.
The source change is reflected in dCS Mosaic ACTUS.
Using the Remote Control
1. On the Remote Control, select .
The available sources are displayed on the User Interface front panel.
2. Select again to toggle through the sources on the list.
3. To select the highlighted source, wait a few seconds.
The source change is reflected both in dCS Mosaic ACTUS and on the User Interface
front panel.
Managing power options
Configure how your system behaves when it is not active. The system includes the following
power states:
Power
state
Description
Sleep Units consume very low power and can only be woken by pressing the power button on
the front panel.
Standby Units consume low power but remain connected to the network.
You can turn on the system from the unit, from the Remote Control or using dCS Mosaic
ACTUS.
Rest
mode
The system can start playback quickly and you can charge the Remote Control using the
USB socket at the rear of the Core.
1. On the home page of the app, select .
2. Select .
3. On the Settings screen, select System.
4. On the System screen, select Power management.
5. On the Power management screen, toggle power options according to your needs:
Getting started
Varèse User Guide
9
To Next Page
Loading...