DCS VARESE - Changing the Absolute Phase of Analogue Outputs; Adjusting the Output Voltage; Customising the Remote Control Hot Key; Locking the System

18
Changing the absolute phase of analogue outputs
When listening to music, if the character of the instruments sounds wrong then it may be
because the track was recorded with both channels phase-inverted. You can correct the
absolute phase of the outputs using dCS Mosaic ACTUS.
The Phase setting can be found on the Volume control screen of dCS Mosaic ACTUS or
on the User Interface.
Adjusting the output voltage
Select an output voltage that is suitable for your hardware and guarantees optimal sound
quality.
CAUTION
High voltage may cause damage to equipment connected to system analogue outputs.
1. On the home page of the app, select .
2. Select .
3. On the Settings screen, select Audio.
4. On the Audio screen, select Output voltage.
5. On the Output voltage screen, select the required voltage.
Customising the Remote Control hot key
You can customise the shortcut button on Remote Control using dCS Mosaic ACTUS.
1. On the home page of the app, select .
2. Select .
3. On the Settings screen, select Remote Control.
4. On the Remote Control screen, in Customise hot key, select the hot key function
you wish to assign to the Remote Control.
Locking the system
You can lock all your system settings to only allow access to music control, volume, and
power.
1. On the home page of the app, select .
2. Select .
3. On the Settings screen, select System.
4. Select Privacy & security and then select System lock.
5. Confirm your selection.
All settings are now locked and this setting now changes to Disable system lock.
Configuring Varèse
Varèse User Guide