EN-4
4 CONFIGURATION OF THE CONTROL PANEL
The universal control unit NET24N can be used for the management of the following types ( ) of closures motorized by DEA Sy-
stem: swing and sliding gates, overhead doors and barriers.
In order to ensure maximum adaptability to each
of closure, the control board provides an initial procedure, performed only at the
fi rst turn, for the optimal confi guration of inputs, outputs and parameters (see diagram ). Once confi gured, the control panel will operate
in the mode “dedicated” to the of selected closing. After performing the initial confi guration it is suffi cient to execute the standard
programming for the installation on which it is operating.
All settings remain in memory even in the case of subsequent fl are-ups (see diagram
).
If necessary the
of confi gured closing can be later adjusted following diagram .
FIRST CONTROL BOARD IGNITION
Confi guration after the fi rst ignition
For the fi rst control panel ignition, proceed as fol-
lows:
1. Apply power, the display shows in sequence the
writing “
” and “ ” fl ashing;
2. Press the
button and hold for 5 seconds until
the display shows
on the display;
3. Acting on the and keys, select the desired
confi guration depending on the type of installa-
tion (es. ) and confi rm by pressing the
button;
At this point, the selection will be stored and relo-
aded each time in the future.
4. Follow signs, “ ”, “ ” followed by the
symbol of closed gate “- ---”.
Following ignitions
If you have already saved a confi guration, pro-
ceed as follows:
Apply power, the display shows in sequence the
writing “ ”, “ ”, “ ” followed by the
symbol of closed gate “- ---”.
Modify the existing confi guration
If you have already saved a confi guration and you
want to change it, proceed as follows:
1. Hold down the button and give power, the di-
splay shows in sequence the writing “ ” and
“ ” fl ashing;
2. Press the button and hold for 5 seconds until
the display shows
(the value changes to
match the previous confi guration used) on the
display;
3. Acting on the
and , select the new desired
confi guration depending on the type of installa-
tion (es.
) and confi rm by pressing the
button;
Stop the reconfi guration procedure prior
to confi rmation, involves loading the previous
confi guration by the control panel without any
modifi cation.
However, if the reconfi guration procedure is
brought to an end, the new confi guration will
take the place of the previous one and will be
reloaded each time in the future.
4. Follow signs, “ ”, “ ” followed by the
symbol of closed gate “- ---”.
Sliding gates
Swing gates
Overhead doors
Barriers
To Next Page
Loading...
Need help?
General
