Table 6–4 (Cont.): Software Error Messages
Message Meaning Corrective Action
42 ERROR There is an expansion
interface error.
Power off the printer and verify that
any memory expansion boards are
correctly installed. If the problem
continues, call your Digital service
representative (Chapter 8).
43 ERROR There is an expansion
interface error.
Power off the printer and verify that
any memory expansion boards are
correctly installed. If the problem
continues, call your Digital service
representative (Chapter 8).
FE FONT REMOVAL A font cartridge has
been removed from
the printer.
Power off the printer and install the
font cartridge before powering the
printer back on.
CAUTION: To prevent damage to the
font cartridge or the printer, always
turn the printer off before removing a
font cartridge.
If you do not want to use the font
cartridge, power off the printer and
wait at least two seconds, then power
it back on.
FF FONT FULL The font registration
area is full.
Reduce the number of fonts in
memory.
Clear fonts from memory after each
job.
Add RAM.
Troubleshooting 6–7
To Next Page
Loading...