DECRVEC—Draw Relative Vector
CSI Ps1 ; Pn2 ; Pn3 SP |
Where:
Ps1 = 0 Draws a horizontal (X) line to the right.
Ps1 = 1 Draws a vertical (Y) line down.
Ps1 = 2 Draws a horizontal (X) line to the left.
Ps1 = 3 Draws a vertical (Y) line up.
Pn2 = n Is the line length according to the SSU sequence.
Pn3 = n Is the line width according to the SSU sequence.
DECSCL—Set Conformance Level
CSI Ps " p
Where:
Ps = 0 or 73 Resets to DEC PPL3 defaults.
DECSDPM—Set Duplex Print Mode
CSI Ps SP x
Ps Print Mode
Physical
State
Tumbling
State
0 True simplex normal Simplex Off
1 True simplex normal Simplex Off
2 True simplex tumbled Simplex On
3 True duplex normal Duplex Off
4 True duplex tumbled Duplex On
5 Duplex master normal Simplex Off
6 Duplex master tumbled Simplex On
7 Simplex compressed normal Duplex Off
8 Simplex compressed tumbled Duplex On
A–24 Operator’s Guide
To Next Page
Loading...