Built-in Font Files: The DEClaser 2200 plus has 36 built-in font files
that can be used with DEC PPL3. The font files
consist of four fonts and nine character sets. These
fonts are:
• Courier 10-point normal
1
portrait
• Courier 10.3-point normal portrait
• Courier 6.7-point normal landscape
• Elite 10-point normal portrait
For each font the following character sets reside
in the printer:
• ASCII
• DEC Supplemental
• ISO Latin-1 Supplemental
• DEC Technical
• DEC Special Graphics (VT100 Line Drawing)
• DEC 7-Bit Hebrew
• DEC Hebrew Supplemental
• ISO Latin-Hebrew Supplemental
• Legal
Font Cartridges: Capacity for two optional font cartridges
Built-in RAM: 1.0 MB, expandable to 4.0 MB
with optional RAM boards
Host Interface: Parallel (Centronics) and serial (RS232C)
Acoustic Noise: 40dB(A) maximum during standby
53dB(A) maximum during printing
Operating Temperature: 10°C to 32.5°C (50°F to 90.5°F)
Operating Humidity: 20% to 80% relative humidity
Storage Temperature: 0°C to 35°C (32°F to 95°F)
Storage Humidity: 10% to 80% relative humidity
1
Normal means that the font is not set in bold or italics or otherwise attributed.
C–2 Operator’s Guide
To Next Page
Loading...