DEC 220240 - Page 97

Table 4–6 (Cont.): Changing and Saving Values
Operation Display Reads
6. Press

until the
value equals -10.0.
NOTE: The value decreases
in steps of 0.5.
offsetX -1
0.0
7. Press

Enter
to enter
the new value.
offsetX =-10.0 (momentarily)

offsetX offsetY
8. Press

once to scroll
the display to the offsetY feature.
offsetY autoNL o
9. Press

Enter
to select
the offsetY feature.
offsetY =+0.0
10. Press

until the
value equals -10.0.
NOTE: The value decreases
in steps of 0.5.
offsetX -1
0.0
11. Press

Enter
to enter
the new value.
offsetY =-10.0 (momentarily)

offsetY autoNL o
12. Press

to return
to the menu selections.
LAYOUT COPY/OVER
13. Press  three
times to reach the
NVRAM SAVE menu.
SAVE->NVRAM LOAD
14. Press

Enter
to save
the offset values in
NVRAM.
OK (momentarily)

SAVE–>NVRAM LOAD
4–12 Operator’s Guide