Figure 2–3 shows a successful power-up and automatic boot when DIA0
has been selected as the boot device.
Figure 2–3: Successful Power-Up and Automatic Boot
KA660-A Vn.n, VMB n.n
Performing normal system tests.
95..94..93..92..91..90..89..88..87..86..85..84..83..82..81..80..
79..78..77..76..75..74..73..72..71..70..69..68..67..66..65..64..
63..62..61..60..59..58..57..56..55..54..53..52..51..50..49..48..
47..46..45..44..43..42..41..40..39..38..37..36..35..34..33..32..
31..30..29..28..27..26..25..24..23..22..21..20..19..18..17..16..
15..14..13..12..11..10..09..08..07..06..05..04..03..
Tests completed.
Loading system software.
(BOOT/R5:0 DIA0)
2..
-DIA0
1..0..
Loading System Software (No Boot Device Selected)
If you have not selected a boot device when the Break Enable/Disable switch
is set to disable, the system runs self-tests and, on completion, issues a list
of bootable devices. You are prompted to select a boot device from the list,
as shown in Figure 2–4.
Operating the System 2–7
To Next Page
Loading...