1. Unscrew the 4 lateral retaining screws in the control panel.
2. Remove the protective cover.
3. Unscrew the 2 bottom plate screws.
4. Lift up the control panel with the bottom plate.
5. Turn the control panel and the bottom plate into position on the short
side.
6. Slide the lips of the bottom plate into the appropriate slots.
7. Tighten the 2 bottom plate screws.
8. Replace the protective cover.
9. Tighten the 4 lateral retaining screws again.
5.3
Transport
Tab.16 Boiler package dimensions
C 330 ECO L (mm)
280 1920
350 1920
430 1920
500 2230
570 2230
650 2230
Important
For work on the C 630 ECO boilers: The features and instructions
described apply to each boiler module.
The boiler is supplied fully assembled on a pallet. See the diagram and
table for the dimensions. The base of the package is a pallet 80 cm wide.
This means that it can be transported with a pallet truck or using four-
wheel transport boards. Without the packaging, the boiler is 720 mm wide,
Fig.13 Rotating the control panel
Fig.14 Boiler package
5 Before installation
28 7600532 - v.11 - 13122018
To Next Page
Loading...
Need help?
General
