41
Careful maintenance ensures proper
operation and good performances over
time.
• 3 CLEANING THE HOOD
MAINTENANCE
HOW TO PROCEED?
PRODUCTS /ACCESSORIES
TO USE
External surface
and accessories
Do not use metallic scrub-
bers, abrasive products, or
hard brushes.
To clean the external surfa-
ce of the hood and the light
housing screen use only
commercially available hou-
sehold detergents diluted in
water. Then rinse with cle-
an water and dry with a soft
cloth.
Grease lter with
extractable unit
open
Activated charcoal
lter
After 30 hours of operation,
the downdraft will signal the
grease lter saturation.
The saturation is signaled by
the ashing of the 4 central
leds. To reset, press the ti-
mer key .
In the ltering version, the acti-
vated charcoal lter shall be re-
placed regularly. To remove the
charcoal lter panel, rst of all it
is necessary to remove the gre-
ase lter grid and then pull the
plastic key of the panel itself,
in order to disengage it from its
seating. Follow these steps in
reverse order to t the activated
charcoal lter. Replace the used
charcoal lter on an average of
every six months.
Grease lters can be washed
by hand or in the dishwasher.
These lters need to be cle-
aned on a regular basis,
otherwise they may repre-
sent a re risk.
Ret the grease lters and
the front panel, making sure
that the panel is properly t
on both sides so that it does
not cause the downdraft to
stop operation.
The hood shall be disconnected
from the electrical network ,by both
unplugging the appliance from the
socket and activating the magnetic
circuit breaker (safety cut-out), befo-
re removing the metal grease lters.
After cleaning operations, ret the
metal grease lters as detailed in the
installation instructions.
To Next Page
Loading...
Need help?
General
