Deep Sea Electronics Plc DSE892 SNMP - 9 Snmp Set; Keypresstable

SNMP SET
057-179 ISSUE: 3
Page 46 of 50
9 SNMP SET
NOTE: It is strongly recommended that the user creates a new Write Community String to
ensure security.
DSE892 supports SNMP SET functionality (SNMP Version V2c). The Write Community String must
be correctly entered into the SNMP Manager.
Parameter
Factory Setting
Write Community String
private
Port number
161 (one below the SNMP Trap Port number configured in the
DSE892).
This allows the SNMP manager to send control commands to the host DSE controller. A controller’s
support of a command is dependant upon the controller type.
9.1 KEYPRESSTABLE
The command (chosen from the list below) is written to
enterprises.dseVendor.dseProduct.dseInstrumentSection.keypressTable.dseKeypressEntry.keypress
in the SNMP manager.
SNMP SET Value
Description
ACT_ON
Simulates pressing the controller Start button
ACT_MAN
Simulates pressing the controller Manual button
ACT_TEST
Simulates pressing the controller Test button
ACT_AUTO
Simulates pressing the controller Auto button
ACT_OFF
Simulates pressing the controller Stop/Reset button
ACT_GEN
Simulates pressing the controller Transfer to Generator button
ACT_MAINS
Simulates pressing the controller Transfer to Mains button
ACT_BUZZ
Simulates pressing the controller Mute button
ACT_S1
Simulates pressing the controller Transfer to S1 button
ACT_S2
Simulates pressing the controller Transfer to S2 button
NO_ACT
No action. Sometimes useful to check that the module is responding,
without it actually performing an operation