DEEPBLU cosmiq+ - Page 14

14
BACK TO INDEX
Next, ensure that Blue-tooth is enabled on your smartphone and place COSMIQ
+
close to your
smartphone. With COSMIQ
+
, navigate to Sync Mode using the MODE button. A countdown
of 1 minute and 30 seconds will begin on the screen.
At the same time, access the Deepblu app and press COSMIQ
+
in the main menu. The app will
automatically start to scan for your COSMIQ
+
. Once it detects your COSMIQ
+
, it will begin the
pairing process. A running rectangle will on COSMIQ
+
’s screen shows that the devices are pairing.
When the pairing process is complete, the COSMIQ
+
Options menu will appear with 3 options:
• Create Logs: Create dive logs using dive data from COSMIQ
+
.
• COSMIQ
+
Settings: Adjust the settings on your COSMIQ
+
.
• Rename COSMIQ
+
: Personalize your COSMIQ
+
by giving it a name.
You only need to pair COSMIQ
+
with your smartphone once. After it has been successfully paired
the rst time, your phone will automatically establish a Blue-tooth connection with COSMIQ
+
when
you sync them in the future.
Step 3: Perform Sync to Adjust Settings
After pairing COSMIQ
+
with your phone, you must choose your preferred settings. Navigate to
Sync Mode on COSMIQ
+
using the MODE button.
At the same time, access the Deepblu App and press COSMIQ
+
in the main menu. Next, choose
COSMIQ
+
Settings from the COSMIQ
+
Options menu.
In the COSMIQ
+
Settings menu you can change the following:
General
• COSMIQ
+
Firmware: Periodic rmware upgrades to COSMIQ
+
’s operating system will be
made available for download. Press Update to upgrade the rmware on your COSMIQ
+
.
• Screen Timeout: Adjust the time before COSMIQ
+
reverts to Standby in Watch Mode. The
default is 20 seconds.
• Measurement Units: Change the distance and temperature units from the Metric system
(meters/°C) to the Imperial system (feet/°F). The default is the Metric system.
• Date Display: Choose to have the current date or the date of your last dive displayed in Watch
Mode. The default setting is to display the current date.
• Default Underwater Mode: Set the mode COSMIQ
+
will activate on entering the water to
Scuba, Bottom Timer or Freedive Mode. The default underwater mode is Scuba Mode.
• Altitude: Set the altitude settings for your dive. Depending on where you are, you can set
COSMIQ
+
to Sea Level or Above 300 meters/985 feet. The default is Sea Level.
• Water Type: Set the water type to Salt Water or Fresh Water. The default setting is Salt Water.
Scuba Mode
• Safety Factor: Choose to alter COSMIQ
+
’s algorithm to Conservative, Normal or Progressive.
The default is Normal.
• Partial Pressure of Oxygen (PPO2): Change the maximum PPO2 limit from 1.2 bar to 1.6 bar.
The default is 1.4 bar.
• Air Mix: Choose the oxygen level based on the type of gas being used in your cylinder
(Standard Air or Nitrox). The minimum is 21% and the maximum is 40%. This setting can also
be adjusted manually using COSMIQ
+
. The default is 21%.
SECTION 4 – OVERVIEW