DEEPBLU cosmiq+ - 5.4 FREEDIVE MODE

27
BACK TO INDEX
5.3.4 Lockdown for 24 Hours
After completing a dive in Bottom Timer Mode, Scuba Mode will be locked for the next 24 hours.
The letters ‘SUF’ will appear on the screen when COSMIQ
+
is in Scuba Mode and it will not be
functional. COSMIQ
+
will not be able to perform any decompression, saturation or desaturation
calculations for 24 hours after a dive in Bottom Timer Mode. If you attempt a dive while Bottom
Timer Mode is locked, it will automatically switch to Bottom Timer Mode upon detection of
pressure. Additionally, the letters ‘SUF’ will appear on the screen when you access the Dive Plan
function and it will not be functional either. Bottom Timer Mode may still be used during this
period of time.
5.4 FREEDIVE MODE
Freedive Mode is designed specically for apnea/freediving. During a dive, COSMIQ
+
measures
the current depth, dive time and water temperature. You can set a Max Depth and/or Max Time
alarm.
5.4.1 Freedive Mode – Preparing to Dive
There are two ways to prepare for a dive in Freedive Mode: water activation or manual activation.
Water activation: If Freedive Mode is your default underwater mode, then simply enter in the
water when COSMIQ
+
is in Standby or Watch Mode. COSMIQ
+
will automatically activate Freedive
Mode once you descend past 2 meters/6.5 feet.
Manual activation: If Freedive Mode is not your default underwater mode, you must activate it
manually. Navigate to Freedive Mode using the MODE button. Enter the water and begin descent
while in Freedive Mode.
NOTE: On the surface, COSMIQ
+
refreshes its sensors and captures data at 15 second intervals.
Therefore, there may be a slight delay between descending below 2 meters/6.5 feet and Freedive
Mode activating. During a dive, the sampling rate in Freedive Mode is 1 second.
When you navigate to Freedive Mode, COSMIQ
+
will stay in Freedive Mode for 30 minutes. It
will enter Standby after 10 minutes, turning off the screen, but it will remain active in Freedive
Mode, ready to activate upon detection of pressure. After 30 minutes of inactivity in Freedive
Mode COSMIQ
+
will revert back to Watch Mode.
5.4.2 Setting Alarms for Maximum Depth and Maximum Time
You can set alarms for maximum time and maximum depth in Freedive Mode. There are two ways
to set the Max Depth and Max Time in Freedive Mode:
1. Using COSMIQ
+
(see below)
2. Using the Deepblu mobile app (see above section 4.5)
SECTION 5 – INSTRUCTIONS FOR USE