EasyManua.ls Logo

DEEPBLU cosmiq+ - Page 31

DEEPBLU cosmiq+
39 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
31
BACK TO INDEX
Dive Alarms Table
Situation Visual/ Sound Alarm Action
Safe Ascent Rate
Exceeded
- Continuous beeping
- Ascent rate bar full
Slow ascent until alarm stops.
CNS=80% - 5 beeps per minute
- ‘CNS’ ashing
- Arrow indicator ashing
End the dive. Conduct a safety stop
and ascend to the surface.
CNS=85% - 10 beeps per 3 seconds
- ‘CNS’ ashing
- Arrow indicator ashing
End the dive. Conduct a safety stop
and ascend to the surface.
MOD Exceeded - Continuous beeping
- ‘PO2’ ashing
- Arrow indicator ashing
Ascend above the MOD. Consider
ending the dive.
No-decompression Limit
Approaching
- 3 minutes left : 3 beeps
- 2 minutes left: 3 beeps
- 1 minute left: 5 beeps
Ascend to a shallower depth.
No-decompression Limit
Exceeded
- 10 beeps for 20 seconds, 10
second pause, repeat for 3
minutes
- Arrow indicator ashing
- Stop indicator and Stop
Countdown Time ashing
- Ceiling indicator and Ceiling
Depth value ashing
Perform a mandatory decompres-
sion stop. Ascend to the Ceiling
Depth indicated in the bottom left
corner of COSMIQ
+
and stay there
until the Stop Countdown Time is
over. Do not ascend above the Ceil-
ing Depth until the Stop Countdown
Time is over.
Battery Power Low - 1 beep every minute Charge COSMIQ
+
as soon as possi-
ble.
COSMIQ
+
Shutting Down - 1 beep Charge COSMIQ
+
immediately.
Max Depth (Freedive
Mode)
- Continuous beeping until
you ascend above the set
depth
Max Time
(Freedive Mode)
- 6 cycles of 3 beeps
Surface Interval Alarm
(Freedive Mode)
- 2 cycles of 2 beeps (surface
interval half completed)
- 2 cycles of 3 beeps (surface
interval completed)
Depth Alarm
(Scuba Mode)
- 6 cycles of 2 beeps
Time Alarm
(Scuba Mode)
- 6 cycles of 3 beeps
SECTION 5 – INSTRUCTIONS FOR USE

Other manuals for DEEPBLU cosmiq+