deerma DEM-VX910W - Base Maintenance and Device Storage; Cleaning Base Tray and Station; Proper Device Storage; Precautions and Battery Disposal

14
Storage of complete device
1. Inse a screwdriver into the handle removal hole
behind the handle assembly, hold the handle assembly
and pull it upwards, and then withdraw the screwdriver
when pulling.
2. Unplug the handle assembly, and then install it back
into the packaging box together with main unit and base.
3. If it is not used for a long time, it shall be packed well
and stored in a cool and d place, not in direct sunlight or
wet environment.
Note: Do not forcibly pull out the handle assembly to
avoid inju.
Precautions
Environmental instructions
The chemical substances contained in the built-in lithium-ion batte of the product will pollute the
environment. Before scrapping, it should be removed by professional personnel and sent to a professional
batte recycling agency for centralized disposal.
• Batte must be taken out before discarding the product. The product must be powered o when taking
out the batte;
• Batte should be disposed of safely.
Caution:
• Do not expose the batte to high temperature, otherwise it may cause explosion.
• In case of batte leakage and accidental contact, immediately ush with plenty of water and seek medical
advice.
The following information is only applicable when discarding the product, and is not the instruction of daily
operation.
1. Press and hold the Handle Removal key on the back of the body with a non-sharp auxilia tool, and pull out
the handle veically;
2. Remove the sewage tank;
3. P four buckles with a slotted screwdriver along the edge of the display screen assembly and the main unit
cover to remove the display screen assembly;
4. Remove the decorative cover of main unit;
5. Unscrew the screws of the middle cover and holder of main unit, and remove the main unit holder;
6. Unscrew the screws that x the batte pack components, and take out the batte pack;
7. Unscrew the upper and lower covers of the batte assembly, and remove the upper cover;
8. Unscrew the xing screws of the batte assembly, pull out the plug of batte assembly, and remove the
batte pack.
Removal of batte
13
Note:
• It is normal that hair and di are adhered to the base tray. It can be washed by clean tap water.
• After the self-cleaning, it is normal that a small amount of sewage remains on the base.
Cleaning of base tray and base
1. The diy base tray can be cleaned with a damp
cloth, or ushed with clean tap water in the direction
shown in the gure, until it is clean. It can be
reinstalled after ding in a ventilated place.
2. After the base tray is removed, any di on the
base can be wiped with a damp cloth.
Handle
removal hole
最高水位
最高水位