Page 13
General information
Service life of the product will extend and the
possibility of problems will decrease if the
product is cleaned at regular intervals
6 Maintenance and care
DANGER
Disconnect the product from
mains supply before starting
maintenance and cleaning
works. There is the risk of
electric shock!
DANGER:
Allow the product to cool down
before you clean it.
Hot surfaces may cause burns!
x Clean the product thoroughly after each
use. In this way it will be possible to remove
cooking residues more easily, thus avoiding
these from burning the next time the
appliance is used.
x No special cleaning agents are required for
cleaning the product. Use warm water with
washing liquid, a soft cloth or sponge to
clean the product and wipe it with a dry
cloth.
x Always ensure any excess liquid is
thoroughly wiped off after cleaning and any
spillage is immediately wiped dry.
x Do not use cleaning agents that contain
acid or chloride to clean the stainless or
inox surfaces and the handle. Use a soft
cloth with a liquid detergent (not abrasive)
to wipe those parts clean, paying attention
to sweep in one direction.
The surface might get damaged
by some detergents or cleaning
materials. Do not use aggressive
detergents, cleaning powders/
creams or any sharp objects
during cleaning. Do not use
harsh abrasive cleaners or sharp
metal scrapers to clean the oven
door glass since they can scratch
the surface, which may result in
shattering of the glass.
Do not use steam cleaners to
clean the appliance as this may
cause an electric shock.
Cleaning the hob
Glass ceramic surfaces
1. Turn off the hotplates and wait until they
cool down.
2. If necessary, clean the plates with a
cleaning agent (you can obtain cleaners/
softeners from specialty stores).
3. Warm only for a few minutes after
cleaning in order to have their top section
dried.
4. Apply a thin layer of machine oil onto the
top surface of the hob regularly in order to
protect it.
Cleaning the control panel
Clean the control panel and knobs with a
damp cloth and wipe them dry
Do not remove the control
buttons/knobs to clean the
control panel.
Control panel may get
damaged!
To Next Page
Loading...
