Page 16
Error codes
Heater display Fault Solution
F0 Touch control software error. If error has occurred disconnect and reconnect the hob
to the power supply. If the error occurs suddenly in a
normal operation or if the error persists, contact the
customer care line.
Fc Touch control zone is too hot and
has turned off all the heaters.
Wait until temperature goes down. The hob will
automatically recover when the temperature reaches a
normal value.
Ft Touch control temperature sensor
may be damaged.
Wait until temperature goes down. If the message
persists then contact the customer care line.
FE Touch control temperature sensor
may be damaged.
Wait until temperature goes down. If the message
persists then contact the customer care line.
FU/FJ Security keyboard error This error is a keyboard auto check. It disappears when
auto check returns to the secure value. If the error
persists, call the customer care line.
FA Security software error This error is a keyboard auto check. It disappears when
auto check returns to the secure value. If the error
persists, call the customer care line.
FC/Fd Security software error This error is a keyboard auto check. It disappears when
auto check returns to the secure value. If the error
persists, call the customer care line.
Fr Relays security error There may be a relay driver problem. Disconnect and
reconnect the hob to the power supply. If the error
persists, call the customer care line.
To Next Page
Loading...
Need help?
General
