Status text Condition Comment
SHUTDOWN OVERRIDE The configurable input is active
ACCESS LOCK The configurable input is activated, and the operator
tries to activate one of the blocked keys
GB TRIP EXTERNALLY Some external equipment has tripped the breaker An external trip is log-
ged in the event log
MB TRIP EXTERNALLY Some external equipment has tripped the breaker An external trip is log-
ged in the event log
IDLE RUN The "Idle run" function is active. The genset will not
stop until a timer has expired
IDLE RUN ###.#min The timer in the "Idle run"’ function is active
COMPENSATION FREQ Compensation is active The frequency is not
at the nominal setting
Aux. test ##.#V ####s Battery test activated
DELOAD Decreasing the load of the genset in order to open
the breaker
START DG(s) IN ###s The start genset set point is exceeded
STOP DG(s) IN ###s The stop genset set point is exceeded
START PREPARE The start prepare relay is activated
START RELAY ON The start relay is activated
START RELAY OFF The start relay is deactivated during the start se-
quence
MAINS FAILURE Mains failure and mains failure timer expired
MAINS FAILURE IN ###s Frequency or voltage measurement is outside the
limits
The timer shown is
the mains failure de-
lay. Text in mains
units
MAINS U OK DEL ####s Mains voltage is OK after a mains failure The timer shown is
the mains OK delay
MAINS f OK DEL ####s Mains frequency is OK after a mains failure The timer shown is
the mains OK delay
Hz/V OK IN ###s The voltage and frequency on the genset is OK When the timer runs
out, it is allowed to
operate the generator
breaker
COOLING DOWN ###s Cooling-down period is activated
GENSET STOPPING This info is shown when cooling down has finished
EXT. STOP TIME ###s
PROGRAMMING LAN-
GUAGE
This info is shown if the language file is downloaded
from the PC utility software
AGC 200 operators manual 4189340607
UK
Display and menu structure
DEIF A/S Page 15 of 24
To Next Page
Loading...
