Deif AGC 200 - Texts Only Related to Power Management (AGC 24 X Only)

4.1.6 Texts only related to power management (AGC 24x only)
Status text Condition Comment
DG unit
BLACKOUT ENABLE This info is shown if a CAN failure is present in a pow-
er management application.
UNIT STANDBY If redundant mains units are present, this message is
shown on the redundant unit.
DELOADING BTB XX DG units are load sharing asymmetrically to deload
BTB XX dividing two sections in an island application.
BTB XX DIVIDING SEC. BTB XX is dividing two sections in an island applica-
tion.
SYNCHRONISING TB XX TB XX is synchronising.
SYNCHRONISING MB XX MB XX is synchronising.
SYNCHRONISING BTB XX BTB XX is synchronising.
Deloading TB XX Displays that a tie breaker is being deloaded in semi-
auto mode.
Mains unit
UNIT STANDBY If redundant mains units are present this message is
shown on the redundant unit.
TB TRIP EXTERNALLY Some external equipment has tripped the breaker. An external trip is
logged in the
event log.
BTB unit
DIVIDING SECTION A BTB unit is dividing two sections in an island appli-
cation.
READY AUTO OPERATION BTB unit in Auto and ready for breaker operation (no
active BTB trip" alarm).
SEMI-AUTO OPERATION BTB unit in Semi-auto
AUTO OPERATION BTB unit in Auto, but not ready for breaker operation
(active "BTB trip" alarm).
BLOCKED FOR CLOSING Last open BTB in a ring bus.
BTB TRIP EXTERNALLY Some external equipment has tripped the breaker. An external trip is
logged in the
event log.
All units
BROADCASTING APPL. # Broadcast of an application through the CAN line. Broadcasts one of
the four applica-
tions from one unit
to the other AGCs
in the power man-
agement system.
AGC 200 operators manual 4189340607
UK
Display and menu structure
DEIF A/S Page 17 of 24