DeLaval SCB3 - Troubleshooting; No. 1 The Brush Does Not Spin; No. 2 The Brush Does Not Switch Off; No. 3 The Brush Makes Strange Noises

Troubleshooting
DeLaval swinging cow brush SCB3
No. Symptom Cause Action
1 The brush does not spin. The mains power supply dis-
connected or no voltage.
Check the wiring and the fuse.
The plug is removed from the
wall socket.
Pull the plug.
The brush is blocked. Clean the shaft and the brush.
2 The brush does not switch
off.
The printed circuit board does
not switch off.
Contact the DeLaval techni-
cian.
Incorrect/faulty electrical instal-
lation.
Contact the DeLaval techni-
cian.
3 The brush makes strange
noises.
Bearing or gearwheel problem. Contact a DeLaval technician.
DeLaval swinging cow brush SCB3
Troubleshooting
© DeLaval 2016.
2016-07-19, Version 5 24 (26) 84948801