What to do if my DeLaval Farm Equipment brush does not spin?
If the DeLaval Farm Equipment brush does not spin, there might be a few reasons. First, check the wiring and the fuse, as the mains power supply might be disconnected or have no voltage. Also, ensure the plug is properly inserted into the wall socket. Finally, the brush could be blocked, so cleaning the shaft and the brush is advisable.
Why does my DeLaval SCB3 Farm Equipment brush make strange noises?
Strange noises from the DeLaval Farm Equipment brush may indicate a bearing or gearwheel problem. In this case, it is best to contact a DeLaval technician for assistance.
What to do if the DeLaval SCB3 brush does not switch off?
If the DeLaval Farm Equipment brush does not switch off, it could be due to the printed circuit board not switching off or an incorrect/faulty electrical installation. In both cases, you should contact a DeLaval technician.
General| Brand | DeLaval |
|---|---|
| Model | SCB3 |
| Category | Farm Equipment |
| Language | English |
General safety and operational instructions for the equipment.
Defines safety-related warning messages like Danger, Warning, Caution, Mandatory, Prohibited, and Note.
Mandatory instructions for safe and correct usage of the equipment.
Increases cow health, comfort, welfare, hygiene and improves milk production. Features automatic on/off.
Provides technical specifications of the DeLaval swinging cow brush SCB3.
Lists and identifies all the physical components of the SCB3 unit.
Lists product and accessory article numbers.
Guidelines for electrical installation by an authorized electrician and manual installation by 2-3 persons.
Information on how the brush is packed and handled during transport.
Instructions for mounting the brush securely onto a wall.
Instructions for mounting the brush onto a steel post.
Steps to install the metal switch plate onto the bolts.
Details the electrical connection and safety requirements for the SCB3.
Safety and connection requirements for electrical power supply.
Diagram illustrating the electrical wiring connections for the brush.
Procedure to switch on the mains supply and the brush.
Steps to turn off the brush, including safety measures for discharging capacitors.
General advice before starting maintenance, including safety precautions and contacting technicians.
Lists scheduled maintenance tasks and their intervals.
Procedure to check the gearbox for oil leaks and when to contact a technician.
Instructions for cleaning the brush cylinder, noting motor unit protection.
Procedure for replacing the brush cylinder.
Identifies causes and actions for when the brush fails to spin.
Identifies causes and actions for when the brush fails to switch off.
Identifies causes and actions for when the brush makes unusual noises.
To Next Page
