3. Remove the silicone hose (A) from the hole
by slowly rewinding the silicone hose onto
the tube wheel using a finger.
4. Pull the silicone hose and remove it from
the hole.
Note! Keep a finger on the tube wheel to
prevent it from revolving too fast. If the tube
wheel rotates freely, the spring will be dam-
aged and must then be replaced.
5. Return the wheel slowly to the start posi-
tion.
6. To fit a new silicone hose onto the tube
wheel, turn the tube wheel 8 times clock-
wise.
7. Push the silicone hose through the hole in
the wheel.
8. Allow the spring to rewind the silicone hose
on to the wheel.
9. Reinsert the sample tube into the silicone
hose.
210242
A Silicon hose
210243
Milk sampler (VMS 2012)
Operators maintenance
© DeLaval 2012.
2012-01-10, Version 1 15 (18) 86352801
To Next Page
Loading...
