Operation
1 About collecting milk samples
A sampling sequence normally takes 24 hours
and is to be stopped after performing a system
cleaning. This way, the sampler will be cleaned
after the sampling.
Before starting a system cleaning, putting the
milking station into manual mode is recommen-
ded. This makes it possible to disconnect the
sampler before milking restarts. Consequently,
milk residues in the milk sampler during storage
or transportation will be avoided. When a system
cleaning is inconvenient or impractical, see the
section "Manual cleaning" in the Operators main-
tenance.
Reports about sampling sequences can be
accessed in the management software. Sam-
pling reports are located in Default Reports >
Milking > Milk Sampling. For more information
about reports, see the help file in the DelPro soft-
ware.
2 Collecting milk samples
There are three main steps when collecting milk
samples:
n Connecting the milk sampler
n Starting a sampling sequence
n Stopping a sampling sequence
Milk sampler (VMS 2012)
Operation
© DeLaval 2012.
2012-01-10, Version 1 5 (18) 86352801
To Next Page
Loading...
