ELECTROMAGNETIC EMISSION WARNINGS
HTEK 2_UM Eng_R4.0_Feb. 2016 Page 7 of 28
Manufacturer’s guide and declaration – Electromagnetic emissions.
Hemotek 2 can be used in electromagnetic environments as specified on this page. The
customer or user of the Hemotek 2 must make sure the equipment is used in this environment.
NOTE: Portable and mobile RF communicators could affect Hemotek 2 during its functioning.
Pay attention.
Guidance and manufacturer’s declaration – Electromagnetic Emission
Hemotek 2 is intended for use in the electromagnetic environment specified below. The costumer
or the user of Hemotek 2 should assure that it is used in such an environment.
Electromagnetic environment – Guidance
Hemotek 2 uses RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interface in nearby electronic equipment.
Hemotek 2 is suitable for use in all
establishments, including domestic
establishments and those directly connected
to the public low-voltage power supply
network that supplies buildings used for
domestic purposes.
Harmonic emissions
IEC/EN 61000-3-2
Voltage fluctuations / flicker
emissions
IEC/EN 61000-3-3
To Next Page
Loading...