Figure 30. Installing a 2.5-inch drive into the 3.5-inch drive adapter
Next steps
1. Install the drive adapter into the drive carrier.
2. Install the drive carrier.
3. If removed, install the front bezel.
Intrusion switch
Removing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Keep the plastic scribe ready.
Steps
1. Disconnect and remove the intrusion switch cable connector from connector on the system board.
NOTE:
Observe the routing of the cable as you remove it from the system.
2. Using a plastic scribe, slide the intrusion switch out of the intrusion switch slot.
PowerEdge R340 installing and removing system components
53
To Next Page
Loading...
