Figure 19. Remove Mezzanine Card
1
Mezzanine card 2 Screw
3 Touch point 4 Connector
5 Release latch
9 (Existing mezzanine card only) Press the release latch and lift the back end of the mezzanine card until it becomes free of the
connector.
10 Remove the blank slot cover or mezzanine card from the storage controller.
Install the Mezzanine Card
Use this procedure to install a mezzanine card.
Steps
1 Angle the front of the mezzanine card into the slot on the front of the storage controller.
Replacing Storage System Components
31
To Next Page
Loading...
