Dell EMC SC5020 - Page 32

Figure 20. Install the Mezzanine Card
1
Mezzanine card 2 Screw
3 Touchpoint (blue dot) 4 Connector
5 Release latch
2 Press down simultaneously on the release latch and the blue dot on the rear of the mezzanine card until the card is secure in the
connector.
3 Insert and tighten the screw that secures the mezzanine card to the storage controller.
4 Replace riser 1 in the storage controller.
5 Replace the cover on the storage controller.
6 Remove the service bae from the chassis.
CAUTION
: To prevent a thermal shutdown of the storage system, the storage controller must be installed within three
minutes of removing the service bae.
7 Install the storage controller in the chassis.
8 Reconnect the cables to the storage controller.
9 Clear the storage controller swap status from the Hardware tab in Dell Storage Manager.
For instructions, see the Dell Storage Manager Administrator’s Guide.
Next steps
1 Use Dell Storage Manager to edit the Storage Center settings and set the operation mode of the Storage Center to Production mode.
2 If you added a mezzanine card to an empty mezzanine card slot, use Dell Storage Manager to congure the new fault domains.
3 Use Dell Storage Manager to send SupportAssist information to technical support.
32
Replacing Storage System Components