Removing the stability foot
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working
inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1. Tilt the computer towards the front until the base is facing up.
2. Remove the two screws (#6-32x6) that secure the stability foot to the computer.
3. Lift the stability foot off the computer.
a. stability foot
b. screws (2)
c. computer
4. Tilt the computer back to the upright position.
20
To Next Page