Dell Alienware Area-51 R4 - 46 Replacing the Front-Bezel Heat-Sensor Cable; Procedure; Post-Requisites

Replacing the front-bezel heat-sensor cable
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working
inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1. Route the front-bezel heat-sensor cable through the bracket.
2. Align the tab on the front-bezel heat-sensor cable on the chassis.
3. Push the release tab on the front-bezel heat-sensor cable and press it into place.
Post-requisites
1. Replace the
PCI fan.
2. Replace the left and right side-panels. See “Replacing the side panels”.
3. Replace the stability foot.
74