Replacing the stability foot
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1 Place the computer on a clean and flat surface with the bottom cover facing
up.
2 Align the tabs on the stability foot with the slots on the bottom cover and
snap the stability foot to lock it in place.
3 Turn the computer over and place it in upright position.
23
To Next Page