Dell D13S - Installing the WLAN Card

c) cooling shroud
d) 3.5-inch hard drive chassis
e) drive cage
3. Perform the following steps to remove the WLAN card from the computer:
a) Remove the M2L3.5 screw to release the plastic tab that secures the WLAN card to the computer [1, 2].
b) Disconnect the WLAN cables from the connectors on the WLAN card [3].
c) Remove the WLAN card from its connector on the system board [4].
Identifier GUID-3959438A-F195-4045-91A0-39F9C0CEDFCC
Status Released
Installing the WLAN card
GUID-3959438A-F195-4045-91A0-39F9C0CEDFCC
1. Insert the WLAN card to the connector on the system board [1].
2. Connect the WLAN cables to the connectors on the WLAN card[ 2] .
3. Place the plastic tab and tighten the M2x3.5 screw to secure the WLAN card to the system board [3].
Removing and installing components
45