About this task
The following image indicates the location of the speaker and provides a visual representation of the installation procedure.
Steps
1. Align and insert the speaker into the slot on the chassis.
2. Press the speaker into the slot on the chassis until the release tab clicks.
3. Route the speaker cable through the routing guides on the chassis.
4. Connect the speaker cable to the connector on the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the removal procedure.
Removing and installing components
15
To Next Page
Loading...
