Steps
1. Disconnect the SFP cable from the connector on the system board.
2. Unroute the SFP cable from the clip on the system board.
3. Remove the two screws (M3x3) that secure the SFP Net board module to the chassis.
4. Slide and remove the SFP Net board module and the cables off the chassis.
5. Remove the screw (M2x3) that secures the M.2 board module to the chassis.
6. Slide and remove the M.2 board module off the chassis.
Installing the Small Form Factor Pluggable (SFP) port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the Small Form Factor Pluggable (SFP) port and provides a visual representation of
the installation procedure.
26
Removing and installing components
To Next Page
Loading...
