Steps
1. Slide and insert the M.2 board module into the M.2 board module slot on the chassis.
2. Replace the screw (M2x3) to secure the M.2 board module to the chassis.
3. Insert the SFP Net board module through the opening at the back of the system.
4. Connect the SFP cable to the connector on the system board.
5. Route the SFP cable through the clip on the system board.
6. Replace the two screws (M3x3) to secure the SFP Net board module to the chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Optional modules
Removing the optional Type-C module
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
About this task
The following image indicates the location of the optional Type-C module and provides a visual representation of the removal
procedure.
To identify the ports and connectors, see the system board connectors.
Steps
1. Remove the two screws (M3x3) that secure the Type-C module to the chassis.
2. Slide and rotate the Type-C module.
3. Disconnect the Type-C cable and the DisplayPort cable from the connectors on the system board.
4. Lift the Type-C module and the cables off the chassis.
28
Removing and installing components
To Next Page
Loading...
