a. Use the folding lines on the mylar sheet to fold the mylar sheet.
b. Insert one end of the mylar sheet under the RTC socket.
c. Insert another end of the mylar sheet under another side of the RTC socket.
3. Align and place the speaker holder into the speaker holder slot on the system board.
4. Replace the screw (M3x5) to secure the speaker holder to the system board.
Next steps
1. Install the heat sink.
2. Install the WLAN card or Small Form Factor Pluggable (SFP) port.
3. Install the memory .
4. Install the solid-state drive assembly.
5. Install the speaker.
6. Install the side cover.
7. Follow the procedure in after working inside your computer.
Removing and installing components
53
To Next Page
Loading...
