Dell Dimension 4600 Series - PCI Cards; Removing and Installing Parts

Back to Contents Page

Removing and Installing Parts
Dell™Dimension™4600SeriesServiceManual

PCI Cards


1. Follow the procedures in "Before You Begin."
2. Lay the computer on its side so that the system board is on the bottom of the inside of the computer.
3. Unscrew and remove the filler bracket for the card slot you want to use.


4. Align the cutout on the bottom of the card with the crossbar in the system board connector. Gently rock the card into the connector until it is fully
seated.


Ensure that the card is fully seated and that its bracket is within the card slot.
PCI Cards
AGP Card
Memory
Front Panel
Drives
Microprocessor
Fan Assembly
System Board
Power Supply
Battery
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual or Product Information
Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
CAUTION: Some network adapters automatically start the computer when they are connected to a network. To guard against electrical shock, be
sure to unplug your computer from its electrical outlet before installing any cards.