Dell Dimension 4600 Series - Technical Specifications

Back to Contents Page

Technical Specifications
Dell™Dimension™4600SeriesServiceManual






Microprocessor
System Information
Expansion Bus
Memory
Drives
Ports and Connectors
Video
Audio
Network
Controls and Lights
Power
Physical
Environmental
Microprocessor
Microprocessor type
Intel®Pentium®4 that runs at
2.26, 2.4, 2.533, 2.66, 2.8, or 3.06
GHz internally and 533 MHz
externally, or 2.4, 2.6, 2.8, 3.0, 3.2,
or 3.4 GHz internally and 800 MHz
externally
Level 1 (L1) cache
8 KB first-level
Level 2 (L2) cache
512-KB or 1-MB pipelined-burst,
eight-way set associative, write-
back SRAM
System Information
System chip set
Intel 865PE or 865G
DMA channels
eight
Interrupt levels
24 APIC mode
System BIOS chip
4 Mb (512 KB)
System clock
533- or 800-MHz data rate
Expansion Bus
Bus types
PCI
Bus speed
PCI: 33 MHz
PCI connectors
three
PCI connector size
120 pins
PCI connector data width
(maximum)
32 bits
AGP
AGP 1X, 4X, 8X
Memory
Architecture
Dual Channel DDR SDRAM
Memory connectors
Four
Memory capacities
128-, 256-, 512-MB or 1-GB
Minimum memory
128-MB DDR SDRAM
NOTE: Between 32 and 64 MB of
system memory may be allocated to
support graphics, depending on
system memory size and other
factors.
Maximum memory
4 GB
Memory type
PC2700 (333-MHz) or PC3200 (400-
MHz) DDR SDRAM
(non-ECC)
Drives
Externally accessible
two 5.25-inch bays
one 3.5-inch bay
Internally accessible
Two bays for 1-inch–high IDE hard
drives