Dynamic and basic volumes support limitations
Dell AppAssure supports taking snapshots of all dynamic and basic volumes. AppAssure also supports
exporting simple dynamic volumes that are on a single physical disk. Simple dynamic volumes are not
striped, mirrored or spanned volumes.
Dynamic disks (except simple dynamic disks as previously described) are not available for selection in the
Export Wizard. Non-simple, dynamic volumes have arbitrary disk geometries that cannot be fully
interpreted. AppAssure therefore does not support the export of complex or non-simple dynamic
volumes.
Managing exports
On the Virtual Standby tab in the Core Console, you can view the status of exports that you have set up,
including one-time exports and continuous exports for virtual standby. On this tab, you can manage
exports by pausing, stopping, removing exports, or viewing a queue of upcoming exports.
NOTE: Only the Dell DL1000, 3 TB with 2 VMs configuration supports the one-time export and
continuous export (virtual standby) capabilities.
1. On the Core Console, navigate to the Virtual Standby tab.
On the Virtual Standby tab you can view a table of saved export settings, which includes the
information described in the following table.
Menu Description
Status
NOTE: The status of the virtual standby configuration, is defined by the
color of the icon.
Green –The Virtual Standby is successfully configured, is active, and not
paused. The next Virtual Standby export will be performed after the next
snapshot.
Yellow – The virtual standby is paused and is still saved by the Core. However,
after a new transfer, the export job will not start automatically and there will be
no new Virtual Standby exports for this agent.
Machine Name The name of the source machine.
Destination The virtual machine and path to which data is being exported.
Export Type The type of virtual machine platform for the export, such as, ESXi, VMware,
Hyper-V, or VirtualBox.
Last Export The date and time of the last export. If an export has just been added but has
not completed, a message will display stating the export has not yet been
performed. If an export has failed or was cancelled, a corresponding message
also will display.
2. To manage saved export settings, select an export, and then click one of the following:
• Pause: To pause the export.
• Resume: To restart a paused export.
58
To Next Page
Loading...
