Accessing the Menu System
1. With the menu off, press the 'MENU' button to open the OSD system and display the main features menu.
While the OSD menu is not showing, use this button to activate automatic setup and adjustment. The following dialog will appear on screen
as the monitor self-adjusts to the current input:
The Auto Adjustment button allows the monitor to self-adjust to the incoming video signal. After using 'Auto Adjustment', you can further
tune your monitor by using the 'Pixel Clock' and 'Phase' controls in the OSD.
NOTE: Auto Adjust will not occur if you press the button while there are no active video input signals, or attached cables.
With the menu off, press the button to display the
'Volume adjustment function.
The "Volume" function adjusts the sound level from the internal speakers.
"+" increase 'volume'
" - "decrease 'volume'
With the menu off, press the button to display the Contrast adjustment function.
The 'Contrast' function adjusts the degree of difference between darkness and lightness on the display screen.
"+" increase the 'contrast'
"-" decrease the 'contrast'
To Next Page
Loading...
