PS4100 Hardware Maintenance Guide Maintaining Drives
12
4. Push the drive completely into the slot (callout 2). The drive handle will begin to close onto the drive
(callout 3).
5. Push in the handle until you hear a click (callout 4).
Figure 9 Installing a 2.5-inch Drive
Verify that the new drive is operational by examining the LEDs on the front panel, as described in
Interpreting Drive LEDs on page 7. In addition, examine the GUI Member Disks window and the CLI
member select show disks command output.
Removing a 3.5-inch Drive
1. Remove the bezel. See Removing the Bezel on page 2.
To Next Page
Loading...
