Installing System Components 55
Removing a Filler Panel
1
Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2
Open the system. See "Opening the System" on page 50.
3
If installed, remove the front bezel. See "Removing the Front Bezel" on
page 49.
4
Pull the filler panel away from the chassis.
Figure 3-5. Removing and Installing a Filler Panel
Installing a Filler Panel
1
Slide the filler panel into the bay until it clicks into place. See Figure 3-5.
2
Replace the front bezel. See "Installing the Front Bezel" on page 49.
3
Close the system. See "Closing the System" on page 51.
1 filler panel
book.book Page 55 Monday, March 7, 2011 2:24 PM
To Next Page
Loading...
