Dell Force10 S2410-01-10GE-24P - Page 253

Layer 3 Routing | 253
Figure 17-221. IGMP Proxy Topology
Figure 17-222. Configuring an Interface to Enable IGMP Proxy
To set the report interval, use the ip igmp-proxy unsolicit-rprt-interval command:
Figure 17-223. Configuring an Interface to Enable IGMP Proxy
Force10 #config
Force10 (Config)#ip routing
Force10 (Config)#ip multicast
Force10 (Config)#ip igmp
Force10 (Config)#interface 1/0/48
Force10 (Interface 1/0/48)# no shutdown
Force10 (Interface 1/0/48)#routing
Force10 (Interface 1/0/48)#ip address 4.4.4.4 255.255.255.0
Force10 (Interface 1/0/48)#ip igmp-proxy
Force10 (Interface 1/0/48)#exit
Force10 (Config)#interface vlan 2
Force10 (conf-if-vl-2)#ip address 4.4.4.4 255.255.255.0
Force10 (conf-if-vl-2)#ip igmp-proxy
Force10 (conf-if-vl-2)#untagged 1/0/48
Force10 #config
Force10 (Config)#interface 1/0/15
Force10 (Interface 1/0/15)#ip igmp-proxy ?
<cr> Press Enter to execute the command.
reset-status Reset All the proxy interface status parameters.
unsolicited-report-interval Configure IGMP Proxy unsolicited report interval.
Force10 (Interface 1/0/1)#ip igmp-proxy
Force10 (Interface 1/0/15)#ip igmp-proxy unsolicit-rprt-interval 260
Force10 (Interface 1/0/15)#exit
Force10 (Config)#