Dell Force10 S2410-01-10GE-24P - Page 259

Layer 3 Routing | 259
4. Enable OSPF for the ports and set the OSPF priority and cost for the ports.
Figure 17-236. Using the ospf priority Command
Force10 (Config)#interface 1/0/2
Force10 (Interface 1/0/2)#ip ospf
Force10 (Interface 1/0/2)#ip ospf areaid 0.0.0.2
Force10 (Interface 1/0/2)#ip ospf priority 128
Force10 (Interface 1/0/2)#ip ospf cost 32
Force10 (Interface 1/0/2)#exit
Force10 (Config)#interface 1/0/3
Force10 (Interface 1/0/3)#ip ospf
Force10 (Interface 1/0/3)#ip ospf areaid 0.0.0.3
Force10 (Interface 1/0/3)#ip ospf priority 255
Force10 (Interface 1/0/3)#ip ospf cost 64
Force10 (Interface 1/0/3)#exit